Sennheiser NET 1 Especificaciones descargar pdf (Pagina 19)

왘 Place the transmitter in front of the infra-red interface . The distance

between the infra-red interface of the NET 1 and the infra-red interface of

the transmitter should be approx. 10 cm.

왘 On the NET 1, press the channel button  of the receiver whose frequency

you want to transfer.

The green “CHANNEL” LED  of the selected receiver flashes rapidly,

indicating that data is being transferred to the transmitter.

When the frequency transfer is completed, the green “CHANNEL” LED 

stops flashing and lights up permanently.

If the frequency transfer to a transmitter was unsuccessful, the “ERROR”

LED  flashes rapidly for approx. 3 seconds. You then have to repeat the

frequency transfer.

If all frequencies have been successfully transferred to the transmitters, the

yellow “DATA LINK” LED  lights up permanently.

왘 If necessary, repeat the above steps for the next frequency range.

Transferring frequencies without a prior frequency preset scan

With the NET 1, you can also transfer the set receiving frequency of a

connected receiver to the corresponding transmitter without having

performed a frequency preset scan. To do so, follow the steps described for

transferring frequencies after having performed a frequency preset scan

from page 19 onwards.

Cancelling the frequency preset scan or frequency transfer

왘 Press the MODE button  to cancel the frequency preset scan.

When cancelling the frequency preset scan, all receivers maintain their

receiving frequency.

왘 While the frequencies are being transferred, press the MODE button  or

one of the channel buttons  in order to cancel the frequency transfer to

the transmitters.

When cancelling the transfer, all transmitters whose frequency has not

yet been modified maintain their transmission frequency.

10 cm









1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Sin comentarios

Sennheiser NET 1 Especificaciones Pagina 19