Sennheiser HD400 Manual de usuario descargar pdf (Pagina 28)

Edit Mode

4•6

Routing

Conﬁgure the position of the FX Loop Send/Return.

• Pre - Positions the FX Loop before the Amp model (and between FX1 and FX2, if

these FX are also set “Pre”).

• Post - Positions the FX Loop after the Amp model (and between FX1 and FX2, if

these FX are also set “Post”) within the signal ow.

Send & Return Levels

Use these options to attenuate the Send level fed into your external FX and the Return

level fed from your external FX back into the POD HD400 signal path. (Also use the FX

LOOP LEVEL switch, as mentioned on the previous page.)

Mix

Adjust the amount of the FX Loop signal that is fed to the Send, and thus blended with

your tone. At 100%, the full signal is fed to the FX Loop.

Note: Factory Presets are typically created with the Mix set to 100%, therefore, if you

engage the FX LOOP footswitch with no connections to the SEND and RETURN jacks,

you will hear silence.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 80 81

Sin comentarios

Sennheiser HD400 Manual de usuario Pagina 28